A pair of doorcards                               New set of Clips                   Template kit & Fitting guide

    You get a pair of doorcards, a full set of new clips, our Insert Template kit and our Fitting guide.

    
The idea of the kit is to give you an accurate inside shape if you decide to make yor own inserts.
These could be: carbon fibre, fur, suade, leather.. up to your imagination!

When prepared, the doorcards can be fit very easily, the same as an original.

All the holes are pre-drilled in the backing, but not the moulding. This way, you can put through only the holes that you require (or ask us to do it when placing your order if you are not sure).

              Fitting Guide
1                                                 2

Remove the door furniture - handles, pocket if fitted..              Use a flat screwdriver between the card and door to
                                                                                                        lever the clips out of their holes. (indicated above)
                                                                                                        9 in total.     N.B. Be carefull not to damage the paintwork.

3                                                   4

Drill through the holes you require for your door.                     Insert the new clips into the mdf backing, position onto Also at this point, prepare the speaker hole.                           the door, and clip on.
                                                                                                      N.B. you may need to lever out the top rail a small amount

5

Re-fit furniture and put in the speaker. Ready to go!

If you have any questions about the fitting, please e-mail us